講演抄録/キーワード |
講演名 |
2012-07-19 16:45
オープン・ショート法を利用した広い平板導体のインピーダンス測定法の検討 ○横道太志・稲葉 潤・下塩義文(熊本高専)・宮崎芳郎(矢崎総業) EMCJ2012-40 |
抄録 |
(和) |
船や車などを構成する大きな導体は,その本来の役割とは別に一般に船内や車内で使用される各種電気・電子機器に必要な電源あるいは信号の帰路としての役割,また各種電気系の基準電位としての役割もある.導体に何らかの高周波信号や大電流が流れた場合,導体のインピーダンス特性により電圧が生じ,基準導体としての役目を果たさないことが考えられる.そこで,導体のインピーダンス特性を明らかにする必要がある.しかし,大きな導体のインピーダンスを測定する場合,測定器から被測定物までのケーブルを用いる必要があり,この影響を完全に除去することは非常に難しい.そこで,本論文では伝送線路の一次定数を測定する方法であるオープン・ショート法を用いて大きな平板導体のインピーダンスを測定する方法を提案し,実際に測定を行った結果について報告する. |
(英) |
We propose an impedance measurement method for wide and flat metal sheet. Usually it is difficult to measure accurately the impedance of wide and flat metal sheet because it cannot be eliminated the unnecessary impedance of the long probe which is essential to connect an impedance meter and the metal sheet. For measurement, a thin copper wire is placed at several millimeters high on the metal sheet so that the wire and sheet form a transmission line. Then two input impedances are measured for the transmission line in each case of that the far end termination of the transmission line is open or short. From the measured impedances, four parameters, R, L, G, and C of the transmission line are calculated and an impedance of the metal sheet, which consists of resistance and inductance, is obtained with appropriate correction for skin effect. |
キーワード |
(和) |
インピーダンス測定 / 内部インダクタンス / 表皮効果 / オープン・ショート法 / グラウンドインピーダンス / 平板導体 / / |
(英) |
Impedance measurement / Internal inductance / Skin effect / Open-short method / Ground impedance / Metal sheet / / |
文献情報 |
信学技報, vol. 112, no. 130, EMCJ2012-40, pp. 45-50, 2012年7月. |
資料番号 |
EMCJ2012-40 |
発行日 |
2012-07-12 (EMCJ) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMCJ2012-40 |